Dwyer A-464 Instrukcja Użytkownika Pobierz pdf (Strona 2)

Panel Mounting

Panel mounting is accomplished following most of the steps

listed for wall mounting. Some of the differences are listed

below:

• Use the appropriate length and type of mounting screws for se-

curing the mounting plate (A1) to the panel.

• If the high and low references are remote from the panel, con-

nect the pressure sensing tubing to the appropriate ports on the

gage.

• If clearance behind the gage is a concern, the side ports on the

gage may be used.

To use the side ports, install the factory supplied plugs on the

back ports and install the barbed fittings supplied with the gage

on the side ports.

Note: Install the barbed fittings on the side ports after the gage

is mounted on the panel.

LOW

HIGH

LOW

HIGH

INSTALLATION DIAGRAM

DWYER INSTRUMENTS, INC.

Phone: 219/879-8000 www.dwyer-inst.com

P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]

A-27-M:A-27-M 7/16/10 9:37 AM Page 2

1 2

Brak uwag

Dwyer A-464 Instrukcja Użytkownika Strona 2